The diagnosis of the horizontal parting flaskless molding machine is divided into four steps. It is checked step by step. After the cause is diagnosed, corresponding measures are taken to allow the sand molding machine to continue to work and produce.

The horizontal parting flaskless molding machine is the main equipment on the molding line, and the sand molding machine tends to be sluggish and slow after a period of use. These conditions will affect the efficiency of the molding equipment.

At this time, it is necessary to diagnose the molding machine, analyze the cause of this situation, and deal with it in time to ensure the restoration of the molding machine.

The first step is to open the cover plate on the indenter of the horizontal parting flaskless molding machine and observe whether the rack inside is seriously corroded. If this state is found, the molding equipment and the indenter will be sluggish. At this time, it can be cleaned with kerosene or gasoline to eliminate the corrosion.

If the first step does not occur, start the second inspection. At this time, you should open the flanges on both sides of the indenter to check whether the Y-shaped seals on both sides of the rack are aging or deformed. If this situation still occurs, it will be slow to shape the indenter.

If the first two cases have not occurred, the third step of the inspection will start. At this time, you need to open the upper flange at the rear of the head of the molding machine. What you need to check is whether the butter of the gear bearing has deteriorated. If this happens, it can be washed with kerosene or gasoline, and moving the indenter will feel looser.

The fourth step is to check that there is a foreign matter such as an iron ballast in the gap between the front and back plates of the horizontal parting flaskless molding machine. After removing the foreign matter, you can test run.
If none of the above conditions occur, open the two intake pipes on the back of the indenter, pull the control valve in place and swing them in, and check whether the intake air of the nozzle is large enough. If the intake air volume is small, it will also cause pressure on the molding machine. The head oscillates slowly. If this is the case, check the control valve and then the air filter.

Last Step, when the sand molding machine does not work normally after being turned on, you need to immediately stop the diagnosis. You can diagnose the molding machine in sequence according to the above five steps and handle it in time to make the molding machine operate normally and improve the working efficiency of the machine.

Maybe you are also interested in the Bolg, click here for view more:

1. Full automatic sand molding machine failure detection method

Delin Company is a well-known Chinese automatic sand casting machinery manufacturer, which can provide quotation and export of sand casting machines to various countries. You can click here: automatic molding machine to view more introduction, and maybe you are interested in machine video: DL-3040 automatic sand molding machine working video

If you want to know more details like are we manufacturers? machine function? support video and more pictures? price list? how to buy? Welcome to Call / WhatsApp or send us Email about any question on the machine, please contact us >>>Tel / WhatsApp / WeChat: +86 13960339790, Email: [email protected]